Chord Electronics does not permit this product to be ordered via an online shopping cart. Please contact us by phone or email for more information or to order. Thank you very much.
The CPA 3000 has four balanced inputs with three unbalanced RCA inputs and, on the output side, there is one pair of balanced XLR outputs and a single pair of unbalanced RCA outputs.
The CPA 3000 retains the record output facility shared with the CPA 2500: a single tape loop is available for playback and also to record from any of the connected sources. The CPA 3000 benefits from features like proprietary high-frequency switch-mode power supply and ultra-low-noise circuitry, to give the very best noise floor performance.
The front panel controls allow for easy input and output selection and a remote control offers further flexibility. The fascia features a large easy-to-read vacuum fluorescent display and on the CPA 3000, signal-detection indicators have been replaced with highly accurate VU meters giving both clear signal detection and accurate input level.
Further features include a precision motorised Alps potentiometer for the volume control, fully balanced A/V bypass circuitry for the direct connection to A/V processors from stereo mode and 12V remote triggering outputs at the rear of the unit, to activate power amplifiers or A/V processors on power-up.
2.5Hz – 200kHz +/- 3dB
Total Harmonic Distortion:
0.002% 20Hz – 20kHz
-100dB on all inputs
Signal to Noise Ratio:
-93dB on all inputs
10Hz @ 90dB, 1kHz @ 90dB, 10kHz @ 90dB, 20kHz @ 85dB
Input Max Voltage:
10v RMS Balanced – 5v RMS Unbalanced
Output Max Voltage:
15v RMS Balanced – 5v RMS Unbalanced
0mV (Both Channels)
0dB 0.5dB, -20dB 0.2dB, -60dB 0.24dB (13seconds Full Travel)
Fixed at x 1.1
94 kΩ Balanced – 75 kΩ Unbalanced
100Ω (Short Circuit Protected)
85v – 270v AC (50Hz – 60Hz) Auto Switching
Dimensions Without Integra Legs:
420mm (w) x 355mm (d) x 88mm (h)
Dimensions With Included Integra Legs:
480mm (w) x 355mm (d) x 128mm (h)